3/11/2024 0 Comments Cs en mastercamsome 3D toolpaths in Mastercam support this.your post will also need to be setup to create the correct code for you control.that control also needs to be able to run 3D compensation.so there is a long list of 'ya buts' here to get 3D compensation to work. 2D Cutter Compensationįor the most part, this type of compensation is not done in 3D toolpaths. For more information on this, have a look at that blog posting here. When in 2D, Compensation Type is setting whether or not to output cutter compensation (typically G41/G42), and if so what value should be used for the radius/diameter compensation in the control. This can lead to some confusion when coming from the 2D toolpath world where 'Compensation type' is an option on some toolpaths. On the containment page in some of the 3D toolpaths there is a section called 'Compensate to'. I received a question about 3D toolpath cotainment.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |